J 2025

Efficiency of aluminium refining on a foundry degassing unit depending on the rotor geometry and the degree of its wear

KOLÍNSKÝ, Jan; Ladislav SOCHA; Jana SVIŽELOVÁ; Tomáš PRÁŠIL; Mariola SATERNUS et al.

Základní údaje

Originální název

Efficiency of aluminium refining on a foundry degassing unit depending on the rotor geometry and the degree of its wear

Autoři

KOLÍNSKÝ, Jan; Ladislav SOCHA; Jana SVIŽELOVÁ; Tomáš PRÁŠIL; Mariola SATERNUS; Tomasz MERDER; Jacek PIEPRZYCA a Josef HÄUSLER

Vydání

SCIENTIFIC REPORTS, 2025, 2045-2322

Další údaje

Jazyk

angličtina

Typ výsledku

Článek v odborném periodiku

Obor

20501 Materials engineering

Stát vydavatele

Německo

Utajení

není předmětem státního či obchodního tajemství

Odkazy

Impakt faktor

Impact factor: 3.900 v roce 2024

Označené pro přenos do RIV

Ano

Kód RIV

RIV/75081431:_____/25:00002905

Organizační jednotka

Vysoká škola technická a ekonomická v Českých Budějovicích

Klíčová slova anglicky

Aluminium refining; Physical modelling; Mathematical model; Rotor wear; Industry test

Štítky

Změněno: 22. 8. 2025 10:04, Ing. Barbora Langšádlová

Anotace

V originále

The article studies the issues involved in refining aluminium alloys when introducing small gas bubbles. A good level of dispersion throughout the entire volume of the degassing unit is achieved by using appropriate rotor geometry and selecting optimal process parameters. This study uses physical modelling employing a water model of a foundry degassing unit. Three pump-type rotors of different designs were tested. Variants A and C with a circular cross-section and cylindrical shape differ in the design and arrangement of the gas flow control blades, while variant B with the shape of a truncated cone is a kind of monolith with control blades placed in the lower part of the rotor. These rotors with were studied, with gas flows ranging from 13 to 21 l/min and rotor speeds ranging from 275 to 425 rpm. Tests included visualisation of the gas injection process and measurement of oxygen removal from water as an analogy of hydrogen removal from liquid metal. Then a mathematical model for the quantitative interpretation of research results was developed, in which the dimensionless parameter of degassing efficiency a was determined, which allows for a simple comparison of its value for all rotors, both new and used. The highest values of parameter a are observed for rotor C, only slightly worse values occur for rotor A, and the most significant differences are visible for rotor B. The research results were validated under industrial conditions – the Dichte Index was calculated for all rotors for selected process parameters and illustrated with porosity samples.

Přiložené soubory

01_Efficiency_of_aluminium_refining_on_a_foundry_degassing_unit_depending_on_the_rotor_geometry_and_the_degree_of_its_wear.pdf
Požádat o autorskou verzi souboru