2022
Using Physical Modeling to Optimize the Aluminium Refining Process
PRÁŠIL, Tomáš; Ladislav SOCHA; Karel GRYC; Jana SVIŽELOVÁ; Mariola SATERNUS et al.Basic information
Original name
Using Physical Modeling to Optimize the Aluminium Refining Process
Authors
PRÁŠIL, Tomáš; Ladislav SOCHA; Karel GRYC; Jana SVIŽELOVÁ; Mariola SATERNUS; Tomasz MERDER; Jacek PIEPRZYCA and Martin GRÁF
Edition
Materials, BASEL, SWITZERLAND, MDPIST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2022, 1996-1944
Other information
Language
English
Type of outcome
Article in a journal
Field of Study
20500 2.5 Materials engineering
Country of publisher
Switzerland
Confidentiality degree
is not subject to a state or trade secret
References:
Impact factor
Impact factor: 3.400
Marked to be transferred to RIV
Yes
RIV identification code
RIV/75081431:_____/22:00002310
Organization unit
Institute of Technology and Business in České Budějovice
UT WoS
EID Scopus
Keywords in English
aluminium; refining; rotary impeller; physical modeling
Links
TH04010449, research and development project.
Changed: 21/3/2023 13:31, Barbora Kroupová
Abstract
In the original language
Concern for the environment and rational management of resources requires the devel-opment of recoverable methods of obtaining metallic materials. This also applies to the productionof aluminium and its alloys. The quality requirements of the market drive aluminium producersto use effective refining methods, and one of the most commonly used is blowing an inert gas intoliquid aluminium via a rotating impeller. The efficiency and cost of this treatment depends largelyon the application of the correct ratios between the basic parameters of the process, which are theflow rate of the inert gas, the speed of the rotor and the duration of the process. Determining theseratios in production conditions is expensive and difficult. This article presents the results of researchaimed at determining the optimal ratio of the inert gas flow rate to the rotary impeller speed, usingphysical modeling techniques for the rotor as used in industrial conditions. The tests were carriedout for rotary impeller speeds from 150 to 550 rpm and gas flow rates of 12, 17 and 22 dm3/min. Theresearch was carried out on a 1:1 scale physical model, and the results, in the form of visualization ofthe degree of gas-bubble dispersion, were assessed on the basis of the five typical dispersion patterns.The removal of oxygen from water was carried out analogously to the process of removing hydrogenfrom aluminium. The curves of the rate of oxygen removal from the model liquid were determined,showing the course of oxygen reduction during refining with the same inert gas flows and rotorspeeds mentioned above.