2024
INTRODUCTION TO THE METHODOLOGY OF THE STUDY OF OPERATIONAL WEAR OF EXPERIMENTAL SHAPED PARTS OF MOULDS FOR HPDC OF ZINC ALLOYS
KOZA, Kamil; Karel GRYC; Ladislav SOCHA; Martin PINTA; Roman KUBEŠ et al.Základní údaje
Originální název
INTRODUCTION TO THE METHODOLOGY OF THE STUDY OF OPERATIONAL WEAR OF EXPERIMENTAL SHAPED PARTS OF MOULDS FOR HPDC OF ZINC ALLOYS
Autoři
KOZA, Kamil; Karel GRYC; Ladislav SOCHA; Martin PINTA; Roman KUBEŠ; Václav SOCHACKÝ; Adnan MOHAMED a Jaromír TROBL
Vydání
OSTRAVA, CZECH REPUBLIC, METAL 2023 Conference Proceedings, od s. 114-120, 717 s. 2024
Nakladatel
Tanger Ltd.
Další údaje
Jazyk
angličtina
Typ výsledku
Stať ve sborníku
Obor
20501 Materials engineering
Stát vydavatele
Česká republika
Utajení
není předmětem státního či obchodního tajemství
Forma vydání
elektronická verze "online"
Odkazy
Označené pro přenos do RIV
Ano
Kód RIV
RIV/75081431:_____/24:00002837
Organizační jednotka
Vysoká škola technická a ekonomická v Českých Budějovicích
ISSN
UT WoS
Klíčová slova anglicky
H11 steel; additive manufacturing; mould parts; wear; 3D scanning; CMM; roughness; zinc alloy; die casting
Štítky
Návaznosti
FW03010323, projekt VaV.
Změněno: 10. 4. 2025 11:06, Ing. Barbora Langšádlová
Anotace
V originále
This research article introduces a methodology for studying the operational wear of experimental shaped parts of moulds for high-pressure die casting (HPDC) of zinc alloys. The study includes roughness analysis and geometric dimensioning and tolerancing (GD&T) based on a coordinate measuring machine (CMM) and 3D scanning to quantify the wear of the mould parts due to contact with the zinc alloy melt and solidifying castings during the HPDC process cycles. The research aims to improve the understanding of the mechanisms of mould wear in HPDC of zinc alloys if different types of steel grades and their production technologies are applied during a hundred thousand casting cycles. The results show roughness and geometrical changes on the surface of shaped parts of moulds made from H11 steel grade conventionally, respectively additively manufactured by selective laser melting (SLM). The results so far have shown that the shaped parts of the mould made of conventional H11 steel after 500,000 or additively manufactured H11 steels show the good shape and surface stability after 100,000 casting cycles. Until now, it has not been possible to determine the negative effect of the given HPDC process on the wear of the studied shape parts of the moulds using the above methods; the analyses will continue until their final wear. In parallel with evaluating the shape and surface of the shaped parts, these parameters are also assessed for the zinc alloy castings. However, the evaluation can't be squeezed into the required scope of this contribution. In the following research phase, also metallographic methods will be applied to study the quality parameters of both shaped mould inserts (after their wear) and castings (after different numbers of casting cycles) too. The final and tested methodology, in connection with other extensive outputs of the research and development carried out within the framework of the solved project, should be helpful for designers and manufacturers of shaped parts of moulds and for the own HPDC of zinc alloys.