J 2022

Research on the Oscillation in Centerless Grinding Technology When Machining Bearing Steel

GAVLAS, Martin; Michal KACO; Vladimir DEKÝŠ; Miroslav ŠPIRIAK; Silvia SLABEJOVÁ et al.

Základní údaje

Originální název

Research on the Oscillation in Centerless Grinding Technology When Machining Bearing Steel

Autoři

GAVLAS, Martin; Michal KACO; Vladimir DEKÝŠ; Miroslav ŠPIRIAK; Silvia SLABEJOVÁ; Andrej CZÁN; Jozef HOLUBJAK; Milena KUŠNEROVÁ; Marta HARNIČÁROVÁ a Jan VALÍČEK

Vydání

Materials, Basel, Switzerland, MDPI, 2022, 1996-1944

Další údaje

Jazyk

angličtina

Typ výsledku

Článek v odborném periodiku

Obor

20501 Materials engineering

Stát vydavatele

Švýcarsko

Utajení

není předmětem státního či obchodního tajemství

Odkazy

Impakt faktor

Impact factor: 3.400

Označené pro přenos do RIV

Ano

Kód RIV

RIV/75081431:_____/22:00002387

Organizační jednotka

Vysoká škola technická a ekonomická v Českých Budějovicích

EID Scopus

Klíčová slova anglicky

centerless grinding; vibrodiagnostics; analysis of the run-up and run-down; boxplot; spectral analysis; STFT; geometric deviation

Štítky

Změněno: 21. 3. 2023 18:34, Mgr. Nikola Petříková

Anotace

V originále

In today’s engineering industry, technical diagnostics presents many advantages for improving the management of machining centers and automated production lines. As the fourth industrial revolution is currently being implemented, which includes machine diagnostics, the idea of adding information from the field of vibrodiagnostics was born. The vibration of the workpiece or machine tool negatively affects the geometric parameters of the machined surfaces of the workpiece. Through vibrodiagnostics, the influence of cutting parameters on the oscillation of a bearing steel workpiece during centerless grinding is investigated. The presented publication deals with the vibration of the mechanical parts of a centerless grinding machine. The oscillations are recorded by acceleration sensors, which are also placed on the support ruler in which the workpieces are guided, and the recorded data are input parameters for statistical processing of acceleration values in the form of statistical characteristics (minimum, lower quartile, median, upper quartile, maximum). In this paper, this procedure was applied for the selection of the optimum cutting parameters (for the speed of the support wheel), where the machining parameters at which the minimum oscillation values occur were selected based on the above-mentioned statistical characteristics. This optimization procedure revealed increased vibration values which reached the highest amplitude on the ruler, namely accelerations of 11 m/s2 , the origin of which was subsequently detected by STFT because the occurrence of resonance events or the excitation of natural frequencies of the machine were suspected. The STFT analysis identified a resonant region at machine start-up determined by the spindle speed which excites the resonance on the machine. The speed range between 1950 and 2150 rpm, which corresponds to the built-up resonance, was provided to the technologists to ensure that the machinebwas not operated around this resonance region at 400 and 760 Hz until the undesired phenomenon was eliminated. The results of the individual measurements provided information on the ideal setting of the cutting parameters and the current state of the machine.

Přiložené soubory

materials-15-04968-v2__1_.pdf
Požádat o autorskou verzi souboru