J 2022

Role of injection pressure on fuel atomization and spray penetration on the Thevetia peruviana and Jatropha curcas biodiesel blends with nanoparticle

WANGA, Xuan; Yaoli ZHANGA; C. KARTHIKEYANB; P. BOOMADEVIC; Josef MAROUŠEK et al.

Základní údaje

Originální název

Role of injection pressure on fuel atomization and spray penetration on the Thevetia peruviana and Jatropha curcas biodiesel blends with nanoparticle

Autoři

WANGA, Xuan; Yaoli ZHANGA; C. KARTHIKEYANB; P. BOOMADEVIC; Josef MAROUŠEK; Omaima NASIFG; Sulaiman ALI ALHARBIH a Changlei XIAA

Vydání

Fuel, OXFORD, OXON, ENGLAND, ELSEVIER SCI LTDTHE BOULEVARD, LANGFORD LANE, KIDLINGTON, OXFORD OX5 1GB, OXON, ENGLAND, 2022, 0016-2361

Další údaje

Jazyk

angličtina

Typ výsledku

Článek v odborném periodiku

Obor

20903 Bioproducts biomaterials, bioplastics, biofuels, bioderived bulk and fine chemicals, bio-derived novel materials

Stát vydavatele

Velká Británie a Severní Irsko

Utajení

není předmětem státního či obchodního tajemství

Odkazy

Impakt faktor

Impact factor: 7.400

Označené pro přenos do RIV

Ano

Kód RIV

RIV/75081431:_____/22:00002367

Organizační jednotka

Vysoká škola technická a ekonomická v Českých Budějovicích

EID Scopus

Klíčová slova anglicky

Dual fuel; Nanocatalyst; Jatropha curcas; Injection pressure; Fuel spray characteristics; Thevetia peruviana

Štítky

Změněno: 20. 3. 2023 20:04, Mgr. Nikola Petříková

Anotace

V originále

This study investigates the effect of the injection pressure on the spray characteristics and atomization of the fuel. The novelty of the work lies in examining the injection pressure (IP) at four different scenarios such as 180 MPa, 200 MPa, 220 MPa and 240 MPa. A series of test conducted in the single cylinder engine at three different concentrations of B10 (5% Jatropha curcas and 5% Thevetia peruviana-50 ppm of Fe2O3), B20 (5% Jatropha curcas and 5% Thevetia peruviana-50 ppm of Fe2O3) and B30 (5% Jatropha curcas and 5% Thevetia peruviana-50 ppm of Fe2O3). All the samples were tested for performance and emission characteristics. Based on the procured results, the combination of the dual biodiesel blends improvised the production of higher brake power and lowered specific fuel consumption. Adding two blends together reduced the overall viscosity of the Thevetia peruviana (yellow oleander oil) since the viscosity of the jatropha is lower than the yellow oleander oil. As the concentration of the blends is increased there is a marginal drop in the brake thermal efficiency, however there is an improvement in the brake specific fuel consumptions. In terms of the combustion efficiency, the heat release rates were improvised upon addition of Fe2O3. With regard to the emissions, there is no significant change in the NOx. Nevertheless, there is a drastic reduction in the HC and CO formation has been witnessed. Among various blends, B30 at 240 MPa of IP reported lower emissions than B10 and B20. In order to examine the fuel atomization and spray characteristics, numerical modelling was applied. At 240 MPa, the fuel mixing rates were higher compared to the other injection pressure

Přiložené soubory

16_Role_of_injection_pressure_on_fuel_atomization_and_spray_penetration_on_the_TP_and_JC_biodiesel_blends_with_nanoparticle.pdf
Požádat o autorskou verzi souboru