CZÁN, Andrej, Richard JOCH, Michal ŠAJGALÍK, Jozef HOLUBJÁK, Andrej HORÁK, Pavol TIMKO, Jan VALÍČEK, Milena KUŠNEROVÁ a Marta HARNIČÁROVÁ. Experimental Study and Verification of New Monolithic Rotary Cutting Tool for an Active Driven Rotation Machining. Materials. Basel, Switzerland: MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, roč. 15/2022, č. 5, s. nestránkováno, 17 s. ISSN 1996-1944. 2022.
Další formáty:   BibTeX LaTeX RIS
Základní údaje
Originální název Experimental Study and Verification of New Monolithic Rotary Cutting Tool for an Active Driven Rotation Machining
Autoři CZÁN, Andrej (garant), Richard JOCH, Michal ŠAJGALÍK, Jozef HOLUBJÁK, Andrej HORÁK, Pavol TIMKO, Jan VALÍČEK (203 Česká republika, domácí), Milena KUŠNEROVÁ (203 Česká republika, domácí) a Marta HARNIČÁROVÁ (203 Česká republika, domácí).
Vydání Materials, Basel, Switzerland, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2022, 1996-1944.
Další údaje
Originální jazyk angličtina
Typ výsledku Článek v odborném periodiku
Obor 20501 Materials engineering
Stát vydavatele Švýcarsko
Utajení není předmětem státního či obchodního tajemství
WWW URL
Kód RIV RIV/75081431:_____/22:00002338
Organizační jednotka Vysoká škola technická a ekonomická v Českých Budějovicích
UT WoS 000774922100001
Klíčová slova anglicky turning; rotary tool; cutting force; actively driven tool; surface texture
Štítky KSTR5, RIV22, SCOPUS
Změnil Změnila: Mgr. Nikola Petříková, učo 28324. Změněno: 20. 3. 2023 17:24.
Anotace
Forced rotation turning appears to be an effective machining method due to higher tool life, time efficiency and acceptable quality. Several studies have been carried out to investigate the basic characteristics of forced rotation machining. So far, tools are used whose design included several components. However, such tools may generate vibrations, which are undesirable in the process. In engineering practice, most vibration problems are solved by reducing the cutting parameters (cutting speed and feed rate), which reduces machining productivity. For this reason, a new type of monolithic rotary tool has been designed that eliminates the design complexity and high assembly accuracy requirements of current rotary tools. Based on the performed experimental research, it is possible to define the influence of cutting parameters on the cutting force. Next, the equation of the cutting force and the resulting roughness of the machined surface was determined. In the introduction, the results of the analysis of machining parameters with a rotary tool were added. The presented solution fundamentally validates the new monolithic tool for forced rotation technology and defines its application for different machining materials
VytisknoutZobrazeno: 29. 3. 2024 15:48