2021
Analysis of causes of porosity change of castings under the influence of variable biscuit height in the filling chamber
GAŠPÁR, Štefan; Ján MAJERNÍK and Jan KOLÍNSKÝBasic information
Original name
Analysis of causes of porosity change of castings under the influence of variable biscuit height in the filling chamber
Authors
GAŠPÁR, Štefan; Ján MAJERNÍK and Jan KOLÍNSKÝ
Edition
Materials, BASEL, SWITZERLAND, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2021, 1996-1944
Other information
Language
English
Type of outcome
Article in a journal
Field of Study
20300 2.3 Mechanical engineering
Country of publisher
Switzerland
Confidentiality degree
is not subject to a state or trade secret
References:
Impact factor
Impact factor: 3.748
Marked to be transferred to RIV
Yes
RIV identification code
RIV/75081431:_____/21:00002239
Organization unit
Institute of Technology and Business in České Budějovice
UT WoS
Keywords (in Czech)
Zachytenie vzduchu; Hliníkové slitiny; Vtokový systém; HPDC; Porezita
Keywords in English
Air entrapment; Aluminium alloys; Gating system; HPDC; Porosity
Changed: 24/1/2022 12:40, Mgr. Nikola Petříková
Abstract
In the original language
Quality properties of castings produced in a die casting process correlate with porosity that is conditioned by a number of factors, which range from input melt quality to setup of technological factors of the die casting, and through structural design of the gating system. One of the primary parameters conditioning the inner soundness of the casting is the liquid metal dose per single operation of die casting. This paper examines the issue of metal dose. The experiments are performed with casting a gate system of an electromotor flange. The gating system examined was die cast with a variable volume of metal dose per single operation. The metal dose was adjusted to reach the height of a biscuit of 10, 20, and 30 mm. The examination of the inner homogeneity of the castings of the individual variants of gating systems with variable height of the biscuit proved that decreasing biscuit height results in an increase of porosity share in the casting volume. The programme MagmaSoft 5.4 revealed the main causes of changes in porosity share. The simulations detected that the change in biscuit height and volume of liquid metal directly influence thermal conditions of the melt in the filling chamber, and in the mould by means of the period in which the holding pressure action is influenced. Simultaneously, the melt flow mode in the sprues and gas entrapment in the melt volume are affected as well. Correlation of the factors consequently influences the final porosity of castings.