2021
Analysis of causes of porosity change of castings under the influence of variable biscuit height in the filling chamber
GAŠPÁR, Štefan; Ján MAJERNÍK a Jan KOLÍNSKÝZákladní údaje
Originální název
Analysis of causes of porosity change of castings under the influence of variable biscuit height in the filling chamber
Autoři
GAŠPÁR, Štefan; Ján MAJERNÍK a Jan KOLÍNSKÝ
Vydání
Materials, BASEL, SWITZERLAND, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2021, 1996-1944
Další údaje
Jazyk
angličtina
Typ výsledku
Článek v odborném periodiku
Obor
20300 2.3 Mechanical engineering
Stát vydavatele
Švýcarsko
Utajení
není předmětem státního či obchodního tajemství
Odkazy
Impakt faktor
Impact factor: 3.748
Označené pro přenos do RIV
Ano
Kód RIV
RIV/75081431:_____/21:00002239
Organizační jednotka
Vysoká škola technická a ekonomická v Českých Budějovicích
UT WoS
Klíčová slova česky
Zachytenie vzduchu; Hliníkové slitiny; Vtokový systém; HPDC; Porezita
Klíčová slova anglicky
Air entrapment; Aluminium alloys; Gating system; HPDC; Porosity
Změněno: 24. 1. 2022 12:40, Mgr. Nikola Petříková
Anotace
V originále
Quality properties of castings produced in a die casting process correlate with porosity that is conditioned by a number of factors, which range from input melt quality to setup of technological factors of the die casting, and through structural design of the gating system. One of the primary parameters conditioning the inner soundness of the casting is the liquid metal dose per single operation of die casting. This paper examines the issue of metal dose. The experiments are performed with casting a gate system of an electromotor flange. The gating system examined was die cast with a variable volume of metal dose per single operation. The metal dose was adjusted to reach the height of a biscuit of 10, 20, and 30 mm. The examination of the inner homogeneity of the castings of the individual variants of gating systems with variable height of the biscuit proved that decreasing biscuit height results in an increase of porosity share in the casting volume. The programme MagmaSoft 5.4 revealed the main causes of changes in porosity share. The simulations detected that the change in biscuit height and volume of liquid metal directly influence thermal conditions of the melt in the filling chamber, and in the mould by means of the period in which the holding pressure action is influenced. Simultaneously, the melt flow mode in the sprues and gas entrapment in the melt volume are affected as well. Correlation of the factors consequently influences the final porosity of castings.