J 2021

Analysis of causes of porosity change of castings under the influence of variable biscuit height in the filling chamber

GAŠPÁR, Štefan; Ján MAJERNÍK a Jan KOLÍNSKÝ

Základní údaje

Originální název

Analysis of causes of porosity change of castings under the influence of variable biscuit height in the filling chamber

Autoři

GAŠPÁR, Štefan; Ján MAJERNÍK a Jan KOLÍNSKÝ

Vydání

Materials, BASEL, SWITZERLAND, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2021, 1996-1944

Další údaje

Jazyk

angličtina

Typ výsledku

Článek v odborném periodiku

Obor

20300 2.3 Mechanical engineering

Stát vydavatele

Švýcarsko

Utajení

není předmětem státního či obchodního tajemství

Odkazy

Impakt faktor

Impact factor: 3.748

Označené pro přenos do RIV

Ano

Kód RIV

RIV/75081431:_____/21:00002239

Organizační jednotka

Vysoká škola technická a ekonomická v Českých Budějovicích

Klíčová slova česky

Zachytenie vzduchu; Hliníkové slitiny; Vtokový systém; HPDC; Porezita

Klíčová slova anglicky

Air entrapment; Aluminium alloys; Gating system; HPDC; Porosity

Štítky

Změněno: 24. 1. 2022 12:40, Mgr. Nikola Petříková

Anotace

V originále

Quality properties of castings produced in a die casting process correlate with porosity that is conditioned by a number of factors, which range from input melt quality to setup of technological factors of the die casting, and through structural design of the gating system. One of the primary parameters conditioning the inner soundness of the casting is the liquid metal dose per single operation of die casting. This paper examines the issue of metal dose. The experiments are performed with casting a gate system of an electromotor flange. The gating system examined was die cast with a variable volume of metal dose per single operation. The metal dose was adjusted to reach the height of a biscuit of 10, 20, and 30 mm. The examination of the inner homogeneity of the castings of the individual variants of gating systems with variable height of the biscuit proved that decreasing biscuit height results in an increase of porosity share in the casting volume. The programme MagmaSoft 5.4 revealed the main causes of changes in porosity share. The simulations detected that the change in biscuit height and volume of liquid metal directly influence thermal conditions of the melt in the filling chamber, and in the mould by means of the period in which the holding pressure action is influenced. Simultaneously, the melt flow mode in the sprues and gas entrapment in the melt volume are affected as well. Correlation of the factors consequently influences the final porosity of castings.

Přiložené soubory

Analysis_of_causes_of_porosity_change_of_castings_under_the_influence_of_variable_biscuit_height_in_the_filling_chamber_-_Majernik.pdf
Požádat o autorskou verzi souboru