2021
Selective Laser Melting of PA 2200 for Hip Implant Applications: Finite Element Analysis, Process Optimization, and Morphological and Mechanical Characterization
PACURAR, Razvan; Petru BERCE; Anna PETRILAK; Ovidiu NEMES; Cristina Stefana Miron BORZAN et al.Základní údaje
Originální název
Selective Laser Melting of PA 2200 for Hip Implant Applications: Finite Element Analysis, Process Optimization, and Morphological and Mechanical Characterization
Autoři
PACURAR, Razvan; Petru BERCE; Anna PETRILAK; Ovidiu NEMES; Cristina Stefana Miron BORZAN; Marta HARNIČÁROVÁ a Ancuta PACURAR
Vydání
Materials, Basel, Switzerland, MDPI, 2021, 1996-1944
Další údaje
Jazyk
angličtina
Typ výsledku
Článek v odborném periodiku
Obor
20501 Materials engineering
Stát vydavatele
Švýcarsko
Utajení
není předmětem státního či obchodního tajemství
Odkazy
Impakt faktor
Impact factor: 3.748
Označené pro přenos do RIV
Ano
Kód RIV
RIV/75081431:_____/21:00002158
Organizační jednotka
Vysoká škola technická a ekonomická v Českých Budějovicích
UT WoS
Klíčová slova anglicky
selective laser sintering; hip implants; acetabular liner; surface roughness; compression; finite element analysis; contact pressure; paraxylene immersion
Změněno: 8. 10. 2021 09:25, Mgr. Nikola Petříková
Anotace
V originále
"Polyamide 12 (PA 22000) is a well-known material and one of the most biocompatible materials tested and used to manufacture customized medical implants by selective laser sintering technology. To optimize the implants, several research activities were considered, starting with the design and manufacture of test samples made of PA 2200 by selective laser sintering (SLS) technology, with different processing parameters and part orientations. The obtained samples were subjected to compression tests and later to SEM analyses of the fractured zones, in which we determined the microstructural properties of the analyzed samples. Finally, an evaluation of the surface roughness of the material and the possibility of improving the surface roughness of the realized parts using finite element analysis to determine the optimum contact pressure between the component made of PA 2200 by SLS and the component made of TiAl6V4 by SLM was performed."