J 2021

Influence of Gating System Parameters of Die-Cast Molds on Properties of Al-Si Castings

GASPAR, Stefan; Tomas CORANIC; Ján MAJERNÍK; Jozef HUSAR; Lucia KNAPCIKOVA et al.

Basic information

Original name

Influence of Gating System Parameters of Die-Cast Molds on Properties of Al-Si Castings

Authors

GASPAR, Stefan; Tomas CORANIC; Ján MAJERNÍK; Jozef HUSAR; Lucia KNAPCIKOVA; Dominik GOJDAN and Jan PASKO

Edition

Materials, SWITZERLAND, MDPI AG, 2021, 1996-1944

Other information

Language

English

Type of outcome

Article in a journal

Field of Study

20301 Mechanical engineering

Country of publisher

Switzerland

Confidentiality degree

is not subject to a state or trade secret

References:

Impact factor

Impact factor: 3.748

Marked to be transferred to RIV

Yes

RIV identification code

RIV/75081431:_____/21:00002136

Organization unit

Institute of Technology and Business in České Budějovice

Keywords in English

Casting mold; Gating system; Mechanical properties of cast; Structural adjustments

Tags

Changed: 31/8/2021 09:25, Mgr. Nikola Petříková

Abstract

In the original language

The resulting quality of castings indicates the correlation of the design of the mold inlet system and the setting of technological parameters of casting. In this study, the influence of design solutions of the inlet system in a pressure mold on the properties of Al-Si castings was analyzed by computer modelling and subsequently verified experimentally. In the process of computer simulation, the design solutions of the inlet system, the mode of filling the mold depending on the formation of the casting and the homogeneity of the casting represented by the formation of shrinkages were assessed. In the experimental part, homogeneity was monitored by X-ray analysis by evaluating the integrity of the casting and the presence of pores. Mechanical properties such as permanent deformation and surface hardness of castings were determined experimentally, depending on the height of the inlet notch. The height of the inlet notch has been shown to be a key factor, significantly influencing the properties of the die-cast parts and influencing the speed and filling mode of the mold cavity. At the same time, a significant correlation between porosity and mechanical properties of castings is demonstrated. With the increasing share of porosity, the values of permanent deformation of castings increased. It is shown that the surface hardness of castings does not depend on the integrity of the castings but on the degree of subcooling of the melt in contact with the mold and the formation of a fine-grained structure in the peripheral zones of the casting.

Files attached