J 2021

Advanced Configuration Parameters of Post Processor Influencing Tensile Testing PLA and Add-Mixtures in Polymer Matrix in the Process of FDM Technology

TÖRÖK, Jozef; Monika TÖRÖKOVA; Darina DUPLAKOVA; Zuzana MURCINKOVA; Jan DUPLAK et al.

Základní údaje

Originální název

Advanced Configuration Parameters of Post Processor Influencing Tensile Testing PLA and Add-Mixtures in Polymer Matrix in the Process of FDM Technology

Autoři

TÖRÖK, Jozef; Monika TÖRÖKOVA; Darina DUPLAKOVA; Zuzana MURCINKOVA; Jan DUPLAK; Jakub KASCAK a Monika KARKOVÁ

Vydání

Applied Sciences, Switzerland, Multidisciplinary Digital Publishing Institute (MDPI), 2021, 2076-3417

Další údaje

Jazyk

angličtina

Typ výsledku

Článek v odborném periodiku

Obor

20501 Materials engineering

Stát vydavatele

Švýcarsko

Utajení

není předmětem státního či obchodního tajemství

Odkazy

Impakt faktor

Impact factor: 2.838

Označené pro přenos do RIV

Ano

Kód RIV

RIV/75081431:_____/21:00002126

Organizační jednotka

Vysoká škola technická a ekonomická v Českých Budějovicích

Klíčová slova anglicky

additive production; composite materials; mechanical properties; standardization; FDM technology

Štítky

Změněno: 25. 8. 2021 14:52, Mgr. Nikola Petříková

Anotace

V originále

The present paper focuses on the configuration possibilities of post -processor influencing mechanical properties of a given test sample produced by the FDM printer from different materials. The research consists of assessing the composite material configurations through a static tensile test conducted on 80 samples produced. The samples were produced based on ISO 527-2 standard, type 1A, with a horizontal position and a layer height of 0.2 mm. The individual samples consisted of four basic groups of materials—the pure Polylactic acid (PLA) plastic (reference sample), and three composite samples with admixtures—PLA matrix with a copper admixture, PLA matrix with an iron admixture, and PLA matrix with a steel admixture. The static tensile test was conducted at a test speed of 5 mm/min. During the research, reference samples (pure PLA) were assessed in five orientations. Samples made of the PLA composite materials with admixtures were manufactured, tested, and evaluated only in the 0◦ orientation. The paper concludes by comparing the results of measurement with the original material, free from additives, and with the researched influence of the orientation of the prints on the resulting mechanical properties of shear samples and their surface structure. In the conducted experiments, the lowest tensile strength has been demonstrated in test samples the orbital transitions and the upper surface layers of which were parallel to the infill.

Přiložené soubory