2021
Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting
MAJERNÍK, Ján and Jan KOLÍNSKÝBasic information
Original name
Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting
Authors
Edition
MATERIALS, BASEL, SWITZERLAND, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2021, 1996-1944
Other information
Language
English
Type of outcome
Article in a journal
Field of Study
20100 2.1 Civil engineering
Country of publisher
Switzerland
Confidentiality degree
is not subject to a state or trade secret
References:
Impact factor
Impact factor: 3.748
Marked to be transferred to RIV
Yes
RIV identification code
RIV/75081431:_____/21:00002058
Organization unit
Institute of Technology and Business in České Budějovice
UT WoS
Keywords in English
HPDC; technologické faktory lití pod tlakem; vtokový systém; slitiny hliníku; zachycení vzduchu
Changed: 10/6/2021 07:45, Mgr. Nikola Petříková
Abstract
In the original language
Distribution of gasses to the cast volume and volume of pores can be maintained within the acceptable limits by means of correct setting of technological parameters of casting and by selection of suitable structure and gating system arrangement. The main idea of this paper solves the issue of suitability of die casting adjustment-i.e., change of technological parameters or change of structural solution of the gating system-with regards to inner soundness of casts produced in die casting process. Parameters which were compared included height of a gate and velocity of a piston. The melt velocity in the gate was used as a correlating factor between the gate height and piston velocity. The evaluated parameter was gas entrapment in the cast at the end of the filling phase of die casting cycle and at the same time percentage of porosity in the samples taken from the main runner. On the basis of the performed experiments it was proved that the change of technological parameters, particularly of pressing velocity of the piston, directly influences distribution of gasses to the cast volume.