J 2021

Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting

MAJERNÍK, Ján a Jan KOLÍNSKÝ

Základní údaje

Originální název

Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting

Vydání

MATERIALS, BASEL, SWITZERLAND, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2021, 1996-1944

Další údaje

Jazyk

angličtina

Typ výsledku

Článek v odborném periodiku

Obor

20100 2.1 Civil engineering

Stát vydavatele

Švýcarsko

Utajení

není předmětem státního či obchodního tajemství

Odkazy

Impakt faktor

Impact factor: 3.748

Označené pro přenos do RIV

Ano

Kód RIV

RIV/75081431:_____/21:00002058

Organizační jednotka

Vysoká škola technická a ekonomická v Českých Budějovicích

Klíčová slova anglicky

HPDC; technologické faktory lití pod tlakem; vtokový systém; slitiny hliníku; zachycení vzduchu

Štítky

Změněno: 10. 6. 2021 07:45, Mgr. Nikola Petříková

Anotace

V originále

Distribution of gasses to the cast volume and volume of pores can be maintained within the acceptable limits by means of correct setting of technological parameters of casting and by selection of suitable structure and gating system arrangement. The main idea of this paper solves the issue of suitability of die casting adjustment-i.e., change of technological parameters or change of structural solution of the gating system-with regards to inner soundness of casts produced in die casting process. Parameters which were compared included height of a gate and velocity of a piston. The melt velocity in the gate was used as a correlating factor between the gate height and piston velocity. The evaluated parameter was gas entrapment in the cast at the end of the filling phase of die casting cycle and at the same time percentage of porosity in the samples taken from the main runner. On the basis of the performed experiments it was proved that the change of technological parameters, particularly of pressing velocity of the piston, directly influences distribution of gasses to the cast volume.

Přiložené soubory

Research-and-evaluation_souhrn.pdf
Požádat o autorskou verzi souboru