MAJERNÍK, Ján a Jan KOLÍNSKÝ. Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting. MATERIALS. BASEL, SWITZERLAND: MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, roč. 14, č. 9, s. 1-16. ISSN 1996-1944. 2021.
Další formáty:   BibTeX LaTeX RIS
Základní údaje
Originální název Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting
Autoři MAJERNÍK, Ján (703 Slovensko, garant, domácí) a Jan KOLÍNSKÝ (203 Česká republika, domácí).
Vydání MATERIALS, BASEL, SWITZERLAND, MDPI, ST ALBAN-ANLAGE 66, CH-4052 BASEL, SWITZERLAND, 2021, 1996-1944.
Další údaje
Originální jazyk angličtina
Typ výsledku Článek v odborném periodiku
Obor 20100 2.1 Civil engineering
Stát vydavatele Švýcarsko
Utajení není předmětem státního či obchodního tajemství
WWW URL
Kód RIV RIV/75081431:_____/21:00002058
Organizační jednotka Vysoká škola technická a ekonomická v Českých Budějovicích
UT WoS 000650558200001
Klíčová slova anglicky HPDC; technologické faktory lití pod tlakem; vtokový systém; slitiny hliníku; zachycení vzduchu
Štítky KSTR3, RIV21, WOS
Změnil Změnila: Mgr. Nikola Petříková, učo 28324. Změněno: 10. 6. 2021 07:45.
Anotace
Distribution of gasses to the cast volume and volume of pores can be maintained within the acceptable limits by means of correct setting of technological parameters of casting and by selection of suitable structure and gating system arrangement. The main idea of this paper solves the issue of suitability of die casting adjustment-i.e., change of technological parameters or change of structural solution of the gating system-with regards to inner soundness of casts produced in die casting process. Parameters which were compared included height of a gate and velocity of a piston. The melt velocity in the gate was used as a correlating factor between the gate height and piston velocity. The evaluated parameter was gas entrapment in the cast at the end of the filling phase of die casting cycle and at the same time percentage of porosity in the samples taken from the main runner. On the basis of the performed experiments it was proved that the change of technological parameters, particularly of pressing velocity of the piston, directly influences distribution of gasses to the cast volume.
VytisknoutZobrazeno: 29. 3. 2024 12:23