PLACHÝ, Jan, Jana VYSOKÁ a Radek VEJMELKA. Mutual correlation between softening point and flow resistance at elevated temperature according to bitumen mass in bitumen sheets. In Yilmaz I.,Decky M.,Rybak J.,Dabija A.-M.,Marschalko M.,Coisson E.,Drusa M.,Segalini A. IOP Conference Series: Materials Science and Engineering. 471. vyd. Spojené království: Institute of Physics Publishing. s. 1-10. ISSN 1757-8981. doi:10.1088/1757-899X/471/3/032078. 2019.
Další formáty:   BibTeX LaTeX RIS
Základní údaje
Originální název Mutual correlation between softening point and flow resistance at elevated temperature according to bitumen mass in bitumen sheets
Název česky VZÁJEMNÁ KORELACE MEZI BODEM MĚKNUTÍ A ODOLNOSTÍ PROTI STÉKÁNÍ V ZÁVISLOSTI NA ASFALTOVÉ HMOTĚ V ASFALTOVÝCH PÁSECH
Autoři PLACHÝ, Jan (203 Česká republika, garant, domácí), Jana VYSOKÁ (203 Česká republika, domácí) a Radek VEJMELKA (203 Česká republika, domácí).
Vydání 471. vyd. Spojené království, IOP Conference Series: Materials Science and Engineering, od s. 1-10, 10 s. 2019.
Nakladatel Institute of Physics Publishing
Další údaje
Originální jazyk angličtina
Typ výsledku Stať ve sborníku
Obor 20102 Construction engineering, Municipal and structural engineering
Stát vydavatele Velká Británie a Severní Irsko
Utajení není předmětem státního či obchodního tajemství
Forma vydání elektronická verze "online"
Kód RIV RIV/75081431:_____/19:00001626
Organizační jednotka Vysoká škola technická a ekonomická v Českých Budějovicích
ISSN 1757-8981
Doi http://dx.doi.org/10.1088/1757-899X/471/3/032078
UT WoS 000465811801029
Klíčová slova česky asfaltové hydroizolační pásy; bod měknutí; asfalt; asfaltová hmota; odolnost za vysokých teplot; metoda kroužek a kulička
Klíčová slova anglicky reinforced bitumen sheets for waterproofing (RBS); softening point; bitumen; mass of bitumen; flow resistance; Method of Ring and Ball
Štítky KST1, RIV19, SCOPUS, WOS
Změnil Změnila: Ing. Anna Palokha, učo 18083. Změněno: 15. 11. 2019 11:17.
Anotace
Bitumen sheets are isolating materials that are used in the building construction, primarily as roof waterproofing, vapor barrier and waterproofing of the substructure. For civil engineering they are applied as the isolation of concrete bridge decks and they are used as the main waterproofing for underground construction. Currently, bitumen sheets mentioned above are modified by polymers of elastomer and plastomer. In the places where the bitumen sheets are exposed to UV radiation or to high temperatures, the manufacturer is, according to the product standards, required to declare the flow resistance at elevated temperatures. This paper deals with the investigation of the interdependence between the flow resistance at elevated temperature and the softening point of the bitumen matter in these bitumen sheets. In practice, the results of this dependence are often used in the production of bitumen sheets during the inter-operative check, where the softening point value determines the value of the flow resistance at elevated temperature. This allows to determine whether the produced bitumen sheets will fulfill the values declared by the manufacturer with advance. Since the test for detection of the value of the softening point takes in average 30 minutes then it is possible to react quickly and efficiently during the production and to make the appropriate corrections. Reinforced bitumen sheets which are used for waterproofing of the isolation of concrete bridge decks were selected as the samples from various manufacturers. In practice, this aforementioned dependency is often cited but it is not explicitly documented by a sufficiently large number of samples. The authors of this article found during the previous research that the dependence is influenced by the temperature value – the higher the temperature, the more obvious is the dependence. For this reason, it is very evident in the case of bitumen sheets modified by polymers of the plastomeric character. The hypothesis, that there exists some relationship between the flow resistance at high temperatures concerning to bitumen sheets and the softening point of the bitumen matter, was confirmed only partially. The aim of the paper is to confirm or refute the hypothesis even for materials modified by polymers of elastomeric character. For this reason, the number of bitumen sheets modified by polymers of both plastic and elastomeric character was increased. Results were formulated based on the statistical evaluation of data obtained from laboratory measurements.
Anotace česky
Asfaltové pásy jsou izolační materiály, které se používají v pozemních stavbách především jako hydroizolace střech, parozábrany a hydroizolace spodní stavby. U inženýrských staveb se používají jako izolace mostovek a u podzemních staveb jako hlavní hyroizolace. V současné době se používají především asfaltové pásy modifikované polymery elastomerického a plastomerického charakteru. V místech, kde je hydroizolace z asfaltových pásů vystavena UV spektru slunečního záření a nebo je zatížena vysokými teplotami je výrobce povinen dle výrobkových norem deklarovat odolnost proti stékání při zvýšené teplotě. Tento příspěvek se zabývá vyšetřování vzájemné závislosti mezi odolností proti stékání při zvýšené teplotě a bodem měknutí asfaltové hmoty v těchto asfaltových pásech. Výsledky této závislosti se v praxi často využívají při výrobě asfaltových pásů během mezioperační kontroly, kdy hodnota bodu měknutí stanoví hodnotu odolnosti proti stékání při zvýšené teplotě. Dopředu (S předstihem) je tak možné stanovit, zda vyrobený asfaltový pás splní hodnoty deklarované výrobcem. Vzhledem k tomu, že zkouška pro zjištění hodnoty bodu měknutí tvá v průměru 30 minut, je možné rychle a operativně ve výrobě zareagovat a provést příslušné úpravy. Jako vzorky byly vybrány asfaltové pásy různých výrobců, které se používají pro izolaci betonových mostovek. V praxi je zmiňovaná závislost často uváděna, ale není explicitně doložena na dostatečně velkém množství vzorků. Autoři tohoto článku během předchozího výzkumu zjistili, že závislost je ovlivňována hodnotou teploty. Čím je teplota vyšší, tím je závislost patrnější. Z tohoto důvodu se výrazně projevuje právě u asfaltových pásů s hmotou modifikovanou polymery plastomerického charakteru. Hypotéza, že existuje nějaký vztah mezi odolností proti stékání za vysokých teplot u asfaltového pásu a bodem měknutí této asfaltové hmoty.tak byla potvrzena pouze z části. Cílem příspěvku je potvrzení či vyvrácení hypotézy i pro pásy modifikované polymery elastomerického charakteru. Z tohoto důvodu došlo k navýšení počtu vzorků asfaltových pásů s hmotou modifikovanou polymery jak plastmerického, tak elastomerického charakteru. Výsledky byly zformulovány na základě statistického vyhodnocení dat získaných laboratorním měřením.
VytisknoutZobrazeno: 29. 3. 2024 13:37